Apacer Technology AP-SRFD255AXXXXR-G Manual de usuario descargar pdf (Pagina 6)

Serial ATA Flash Drive

AP-SRFD255AXXXXR-G

6

© 2008 Apacer Technology Inc. Rev 0.2 (Preliminary)

1.3 Mode Configuration

Apacer SRFD supports 4 static pins that can be used to program a normal operating state. The configuration

of each node uses a combination of the Configuration pins and the Pushbutton (Reset) pin.

Table 1-1: Mode Configuration

1.3.1 Definition

The following method can be used to define the configurations.

Configuration pins set to FAST (RAID-0), SAFE (RAID-1):

A. While the system is powered-up

I. Any configuration change is ignored

II. Physical drive change rules: no drivers accepted; in SAFE (RAID-1) mode, a single driver change

will be accepted with normal driver rules (larger or equal to existing drive)

B. Upon power-up, but with no pushbutton (reset) press

I. Any configuration change is ignored

II. Physical drive change rules: no drivers accepted; in SAFE (RAID-1) mode, a single driver change

will be accepted with normal driver rules (larger or equal to existing drive which must be present)

C. Upon power-up and momentary pushbutton (reset) pressed

I. Only new configuration changes are explicitly accepted (if possible) and all new drives are explicitly

accepted if there is a new configuration

Configuration Pin

1 2 3 4 Mode Example

0100 0 1 0 0 RAID 0

1100 1 1 0 0 RAID 1

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

Comentarios a estos manuales

Sin comentarios